On December 27, Creative3DP launched a Kickstarter campaign for PETFusion 2.0 — and within three hours, the device was fully funded. PETFusion 2.0 is both a PET (polyethylene terephthalate) bottle ...

If there’s one problem with the RepRap, it’s the cost of filament. Sure, there’s also the computationally difficult problem of slicing 3D models, but a 5 to 10 times markup on turning plastic pellets ...

We’re far beyond the heyday of the RepRap project, and the Hackaday tip line isn’t seeing multiple Kickstarters for 3D printers every week. In a way, this is a bit of a loss. The rapid evolution of ...

These items should be in every 3D printer’s toolbox, otherwise any job may wind up taking twice as long to do, and the end results could be less than desired. 3D printers require a lot of support.